Page 5 of 6

Re: Bought a Miata...

Posted: Tue Feb 13, 2018 8:24 pm
by tabasco122
i didnt put a new one on, i was debating but didnt want to spend the money. It was a cheap one though, and i tensioned it too tight.

Re: Bought a Miata...

Posted: Tue Feb 13, 2018 8:42 pm
by aaronatstate
That's a tensile break, and is a direct result of over tensioning the belt. :)

Re: Bought a Miata...

Posted: Tue Feb 13, 2018 9:00 pm
by tabasco122
yeah, happened during a hard 2-3 shift, so im assuming when i tried to get back on the power and clutched out it was just like fuck this shit im out.

Re: Bought a Miata...

Posted: Tue Feb 13, 2018 9:21 pm
by aaronatstate
[quote=""tabasco122""]yeah, happened during a hard 2-3 shift, so im assuming when i tried to get back on the power and clutched out it was just like fuck this shit im out.[/quote]

Yeah, also because a used belt should be tensioned less than a new belt as well, so it was probably severely over tensioned.

Re: Bought a Miata...

Posted: Tue Feb 13, 2018 9:33 pm
by tabasco122
It only had a few thousand miles on it, so i figured it would be good. Plus i spend a few hundred on the top and door cards, so i was trying to be cheap.

Re: Bought a Miata...

Posted: Tue Feb 13, 2018 9:42 pm
by Chris GTO TT
How'd you over tension the belt? It's just a spring and then tighten the bolt holding the pulley in place.

Re: Bought a Miata...

Posted: Tue Feb 13, 2018 9:51 pm
by vr4
[quote=""Chris GTO TT""]How'd you over tension the belt? It's just a spring and then tighten the bolt holding the pulley in place.[/quote]

He put additional pressure on the spring

Re: Bought a Miata...

Posted: Tue Feb 13, 2018 9:53 pm
by tabasco122
^

It looked loosey goosey, didnt think about the fact that it really only needs to be tight on the exhaust cam side.

Re: Bought a Miata...

Posted: Tue Feb 13, 2018 10:01 pm
by Chris GTO TT
:facepalm:

Re: Bought a Miata...

Posted: Tue Feb 13, 2018 10:15 pm
by tabasco122
Probably should have read a guide or something, but its just a miata ;)

Re: Bought a Miata...

Posted: Wed Feb 14, 2018 3:39 pm
by Hans_GZP
You done butt fucked that car!

Re: Bought a Miata...

Posted: Wed Feb 14, 2018 4:17 pm
by tabasco122
Non inteference, it's probably fine. $26 for a gates belt and an hour of my time.

Re: Bought a Miata...

Posted: Wed Feb 14, 2018 4:27 pm
by DCIV
Did you really try and save 26 bucks? I was thinking 100. Lol


Coop

Re: Bought a Miata...

Posted: Wed Feb 14, 2018 4:44 pm
by tabasco122
It was just replaced less than 5k miles ago along with the water pump and some other things.

Re: Bought a Miata...

Posted: Wed Feb 14, 2018 4:48 pm
by Hans_GZP
[quote=""DCIV""]Did you really try and save 26 bucks? I was thinking 100. Lol


Coop[/quote]

Honestly, the belt would have been fine if he weren't retarded. :p

Re: Bought a Miata...

Posted: Wed Feb 14, 2018 4:48 pm
by Chris GTO TT
It would have been just fine had been not put extra tension on the belt... Hell I'm putting my 5k old timing belt back on, but I am not putting any extra pressure on it than the spring does.

Re: Bought a Miata...

Posted: Tue Feb 20, 2018 6:22 am
by tabasco122
miata runs again, now do i use tomorrow to install the projectors and HIDs or do i work on the forester...

Re: Bought a Miata...

Posted: Tue Feb 20, 2018 1:31 pm
by DCIV
Forester.


Coop

Re: Bought a Miata...

Posted: Tue Feb 20, 2018 4:36 pm
by vegasidol
These threads need better titles...

Image

Re: Bought a Miata...

Posted: Tue Feb 20, 2018 6:00 pm
by tabasco122
[quote=""vegasidol""]These threads need better titles...

Image[/quote]

That was the point lol. Greg Chris and I all bought miatas around the same time. Pretty sure there are a few more that people made in jest.